Connecting to a Wireless Network | Trend Micro Service Central

Views:

The wireless connection icon () appears in the upper-right corner of the Full Disk Encryption preboot logon when the endpoint has a detected wireless card installed. If there is no wireless card detected, the wireless network icon does not display.

Note:

The Full Disk Encryption preboot cannot automatically detect the authentication for WEP security. If the authentication type is WEP-OPEN or WEP-PSK, manually specify the security type.

If your enterprise policy does not allow Wi-Fi configuration, the All Access Points and Disconnect buttons will be disabled.

For more information, see the Administrator's Guide for PolicyServer MMC.

Click the wireless connection icon in the upper-right corner of the Full Disk Encryption preboot logon.
The Wireless Access screen appears.
Click All Access Points.
The Wireless Network Configuration screen appears.
Select your network.
- To use a listed network, select the SSID, then click OK.
- To configure an unlisted network, click Other Network, specify the SSID settings, then click Connect.
Important:
Do not close the screen or restart your endpoint during configuration.
Click Close to complete the wireless network setup.