Configuring notifications for Private Access Connector status

Procedure

1. In the Trend Vision One console, go to Administration → Notifications.
2. Click Private Access Connector Status to open its settings panel.
3. Enable the alert toggle in the panel.
4. Configure which Private Access Connector alerts trigger a notification.
   • Private Access Connector disconnected
   • CPU usage threshold reached
   • Memory usage threshold reached
   • Disk usage threshold reached
5. To send notifications to users by email, on the Email tab configure the Recipients list.
   1. Specify email addresses or select from the list of Trend Vision One accounts.

      Note Recently created Trend Vision One accounts may not immediately appear on the list.

   2. Click Send Test Message to send a test notification. To send the test message only to emails you are adding to the recipient list, select Send only to newly added recipients. To send the test message to all recipients, select Send to all recipients.

      Note You must wait a few minutes between sending test messages.

6. To send notifications to webhook channels, on the Webhook tab configure the Webhooks list.
   1. Select webhooks from the managed Webhook List.

      Note If your webhook is not listed, create a new webhook connection by managing webhooks in the Webhook List.

7. To send notifications to users by the Trend Vision One mobile app, on the Mobile tab configure the Accounts list.
   1. Specify the Trend Vision One accounts you want to send notifications to using the mobile app.

      Note Recently created Trend Vision One accounts may not immediately appear on the list.

   2. Click Send Mobile App Installation Link to send users an installation link for the mobile app. To send the installation link only to the accounts you are adding to the Accounts list, select Send only to newly added accounts. To send the installation link to all accounts, select Send to all accounts.
8. Click Save.